Shoe covers for COMFORT / CLASSIC machines are identical and interchangeable because the principle of fasteners and the delivery of shoe covers are the same for the machines. The installation must be observed in accordance with the instruction so as not to damage the cassette with shoe covers. It can be disbanded and shoe covers simply crumbling, after which they can not be installed in the apparatus. To avoid this problem, let's examine how to properly install them step by step.
And so the first step:
For the COMFORT, open the top cover to load the shoe covers into the machine. For the CLASSIC this is the back cover (from the rear end of the unit). Then insert the cassette with shoe covers in the special cells (correctly get into the grooves), so that the arrow on the shoe covers points down the device and was face up to the booty clipping compartment in the COMFORT. In the CLASSIC, it must be installed in such a way that the arrow faces the front of the device.
It is necessary to untie bound knobs in the center of the cassette, namely the tape that holds the shoe covers in the center. Then remove the cardboard on which the arrow is drawn, pulling it up. After that, it is necessary to remove the protective snap rings from the cassette on both sides of the fastening of the shoe covers in the cells. After the sealed rings have been removed, the latches on both sides must be snapped into place.
At the end, you need to close the lid and pull out the first shoe by hand.
That's all. The device is fully ready for stable operation!